Support

Stepper Drives

  1. G901X Step Pulse Multiplier Thank you for purchasing the G901X step pulse multiplier. The G901X is covered under a manufacturer’s warranty for one year from the date of purchase. If you are not 100% satisfied with the G901X you may return it for a full refund, minus shipping charges, provided it is like new cosmetically ...
  2. G213V REV-7 Thank you for purchasing the G213V drive. The G213V is part of Geckodrive’s new generation of CPLD-based microstep drives. It has short-circuit protection for the motor outputs, over-voltage and under-voltage protection, over-temperature protection, reversed power supply polarity protection ...
  3. G210X REV-5 Thank you for purchasing the G210X drive. The G210X microstep drive is warranted to be free of manufacturing defects for 1 year from the date of purchase. Also anyone who is dissatisfied with it or is unable to make it work will be cheerfully refunded the purchase price if the G210X is returned ...
  4. GM215 Product Description The GM215 is a 7A, 80VDC step motor drive with an integrated motion controller. It can be used as a step and direction input motor drive or as motion control enabled drive. The operating mode and mode related functions are set via the 10-position slide switch on side of the drive. The GM215 has ...
  5. GM215 Step Motor Drive This manual covers the GM215 when it's used as a conventional STP/DIR input step motor drive. Go to the GM215 MOTION CONTROLLER MANUAL if the GM215 is used as a motion controller and motor drive.   SWITCH SETTINGS AND CONNECTOR WIRING Figure 1 GM215 SETUP FOR MOTOR DRIVE MODE ...
  6. GM215 Motion Control Setup ...
  7. GM215 Configuration Commands ...
  8. GM215 Motion Commands _______________________________________________________________________________________________________________ MOVE ...
  9. GM215 Program Flow Commands Program flow commands break the normal sequential order of program flow by forcing an out of sequence location of the next command. Commands then execute sequentially again starting at the new location. The main program flow commands are unconditional jumps and loops (GOTO), calls and returns ...
  10. GM215 Miscellaneous Commands ...
Set Descending Direction