G201 Stepper Drive
Please note that this product has been placed on legacy status. This means that it is still manufactured but is not recommended for newer designs.
Please note: The G201 is a legacy product and not recommended for new designs. It is still manufactured for existing applications and replacements.
| Native Resolution | 10 uStep (2000 PPR) |
|---|---|
| Power Rating | 80VDC , 7A maximum |
| Motor Control Type | Stepper |
| Metal Treatment | Anodized Base and Cover |
-
perfect replacement for old g201 board
I replaced 201 with this 210 on my long axis on my cnc , this axis had two motors to move carridge so I was worried I would have to replace both 201 boards to this 210 since the 201 is no longer available. I did not and my old frankenstein ez router cnc i have had for 15 years is purring like a champ again! you just cant keep these ez routers down! they just keep going and going and going and these top of the line gecko components are one of the reasons!!
only complaint i had was those little screw terminals are a pain to get the larger wires into when in the tight space these boards are installed at in my cnc. If the holes for the screw terminals was just a big bigger it would make the change a lot easier. luckily this last one lasted 15 years and only went bad because of damage incurred from substrate falling and cutting wires to motor during operating.